Myson iVector S2, Руководство по установке

Страница: 16 / 40

16
iVector S2
Installation manual
iVector S2 • 2022-07-01
US
2.11 Electrical connections
Electrical connection must be made by a qualified
electrician in accordance with local and national wiring
regulations.
The unit must be connected to the mains supply using a
switched fused spur having 3 mm / 1/8" separation on all
poles.
This appliance must be earthed.
• Switch off electrical supply before making
electrical connections.
• Remove control box cover.
• Make electrical connections to pcb.
• Secure power supply cables using strain relief
clamps attached to the control box.
• Refit control box cover.
2.12 Maintenance
Routine maintenance is essential to keep this product in a
safe and reliable working condition. End user maintenance
activities should be limited to cleaning of the outer casing and cleaning of the air filter at appropriate intervals.
Any other repair or maintenance activity should be
carried out by a qualified installer.
2.13 Cleaning the outer casing
Disconnect electrical supply before carrying out
any cleaning or maintenance activities.
Do not use abrasive cloths or abrasive or
corrosive detergents to avoid damaging the
painted surfaces.
Wait until the parts have cooled down to avoid the risk
of burns. When necessary, clean the outer surfaces
of the iVector S2 with a soft damp cloth.
2.14 Cleaning the air filter
To maintain air flow levels through the unit, air filters
should be cleaned at regular intervals. The frequency
of cleaning should take into consideration the concentration of impurities in the local environment
and duration of operation. Filter cleaning should also
be considered after a period of inactivity.
Removing the filter
• Remove the front grille by lifting it slightly and turn it
until it comes completely out of its seat.
• Remove the filter by pulling horizontally outwards.
A
Lift front grille
C
Filter exposed
B
Rotate grille forward
D
Remove filter
A
B
C
D