Myson iVector S2, Руководство по установке

Страница: 12 / 40

12
iVector S2
Installation manual
iVector S2 • 2022-07-01
US
A
Mounting plugs
C
Screws
B
Brackets
D
Drainage pipe
2.5 Horizontal or ceiling installation (VS, VSI)
ceiling
A A
B
B
C
D
2.6 Mounting front grille safety support (VS)
When the unit is installed horizontally the inlet
grille must be attached to the chassis using the
two tie straps supplied in the accessory bag. This
prevents the grille from falling and ensures safe filter
replacement. Separate the two tie straps then;
• Remove the front grille and completely unscrew the
spring-loaded fixing screws.
• Fix one end of each tie to the chassis using the
spring-loaded fixing screws.
• Fix the other end of each tie to the grille using the
supplied screws.
• Refit the grille.
A
Ties
C
Screw fixing
B
Spring-loaded screws
A
A
B
C
Using the paper template provided, trace on the ceiling the
position of the two fixing brackets and the two rear screws.
Using a suitable drill, make the holes and insert the
mounting plugs (2 for each bracket). Fix the two brackets. Do
not over-tighten the screws. Position the unit on the two
brackets, keeping it in position and then fix the two screws
into the rear toggle bolts, one on each side.
Make sure that there is sufficient inclination of the
unit towards the drainage pipe to facilitate the water
drainage. Additional washers or spacers may be
needed.
Fully tighten all 6 fixing screws.
For installation of the VS versions, horizontal condensation
collection tray accessory kits are available.
Carefully check the inclination of the condensate
pipe. Any backflow can cause water leakage.