2
2
Step 3: Place all components in a 1 qt detergent/water mixture and rinse with a soft nylon brush.
Disassemble the spray bar (remove the left and right silicone plugs) and separate
the nozzles and inserts and immerse for 5 minutes.If too much lime has built up, immerse in the solution for
15 to 20 minutes. It would help if you shake the components from time to time and use lukewarm water.Use
a toothbrush to clean the nozzle area. When the cleaning is complete, rinse all parts with clean water.
Step 4: While immersing the components in the cleaning solution, clean the inside of the ice bin with a soft
brush. Rinse every corner of the inside door, door rails, reservoir, and evaporator frame with clean water.
Clean the upper evaporator tubing.
Step 5: Place the cleaned parts back into place and put the remaining 1qt
into the water trough.
Step 6: Turn on the ice maker. (At this time, the switch of the ice maker is OFF)
Step 7: To start the automatic cleaning, turn the switch to WASH.
Step 8: After the automatic cleaning is completed (+-21 minutes), set the switch to OFF. If there is cleaning
solution remaining in the water trough, use the drain plug to remove the cleaning solution.Install drain plug
again, put 1qt of water into the container, turn the switch to WASH, and circulate water again for 10
minutes. (Rinse function)
Step 9: Once the washing and subsequent rinsing is complete, it will remove the calcareous substance in
the internal piping. If bubbles and so forth are not fully rinsed inside the water trough, repeat Step 8.
Step 10: Washing ends in Step 9.
Step 10 is sanitization. Sanitization should be performed at least once a month. Immerse all components in
Step 2 in 2 qts of disinfectant/water mixture for 10 minutes to sanitize. If the parts are large, pour or spray
the disinfectant/water mixture on the surface. When the sanitization
is complete, rinse all components with the clean water (use the water directly from the tap to prevent cross-
contamination).
Step 11: Using the disinfectant/water mixture and a soft brush, rub and clean the inside of the ice bin.
Rinse every corner of the inner door, door rails, tank, evaporator frame and rinse with clean water (use the
water directly from the tap to prevent cross contamination).
Step 12: Reassemble the components disassembled in Step 10 and leave the switch on OFF.
Step 13: Before proceeding with the sterilization cycle, pour 3 qts of disinfectant/water mixture into the
water trough. Turn the switch to the WASH to perform the automatic sanitization cycle. The disinfectant/
water mixture will automatically run inside the piping to sanitize.
※
Caution:
Wash the ice scoop regularly.
The handle of the ice scoop can be easily exposed to germs by contact with hands.
The detergent may cause burns.
If you accidentally swallow the detergent, do not force yourself to vomit.
Instead, drink large amount of water or milk and contact your doctor immediately.
If the detergent gets on the skin, wash with water.
※
Warning:
Keep the detergent out of children’s reach.
If necessary, remove the top cover and disassemble the evaporator cover, water curtain (piano keys
shaped part - for some products), It is necessary to remove the screws on the front side), ice guide
(the part that guides ice to slide into the bin), and nozzle frame (the part to which the water spraying
nozzle is attached).
