Falcon II RJ-8000 Operation Instructions
22
AP-75080, Rev. 1.1, 04/12/02
7
Media guide
This is used to feed the media smoothly when setting the media and
when printing. There is a built-in ink drying device built in.
8
Media cut groove
Used to cut the media straight when it is cut manually : Roll media
cutting procedure
9
Cartridge cover
This is a cover to protect the user from the internal components of the
unit. This is opened during the following conditions :
When cleaning the cleaning wiper : Cleaning the cleaning
wiper
10
Foot switch
This switch is used to raise and lower the pressure roller.
(64” and 87” only, not included in 50”)
2.4.2. Back
No.
Name
Function
1
AC inlet
This is the inlet interface to which the power plug is connected.
2
Interface connector
This is the connector to which the interface cable is connected.
3
Foot switch connector
This is the connector to which the foot switch cable is attached.
4
Scroller receiver
The scroller is set in the receiver when roll media is used.
5
Insertion slot
This is the slot for inserting media when loading it.
6
Drain tank
This is the storage tank for used ink.
7
Interface slot 1
The network interface board attaches here.
8
Interface slot 2
9
Interface slot 3
This is not used for this printer.
Close it with the cover.
10
Hard disk slot
The hard disk attaches here. When not using a hard disk, keep the
cover closed.
11
Nameplate rating
The type, name, serial number, rating and others of the printer are
labelled here.
12
The waste fluid tube
This is the tube for draining waste fluid from the printer.
Downloaded From ManualsPrinter.com Manuals
