MUTOH Rockhopper II Series, Руководство пользователя

Страница: 47 / 190

Rockhopper II series printers – User’s Guide
47
AP-75095, Rev. 2.0, 24/10/03
Step 3 : Plug the cable correctly to the outlet.
Important :
•
Do not attempt to plug in electrical plugs with wet hands. Doing so may result in
electrical shock.
•
Be sure to use the specified voltage (AC 100V-120V/220V-240V). Otherwise,
electrical shock or fire may occur.
•
Use electricity directly from a power outlet (AC 100V-120V/220V-240V). Do not
put many loads on one electrical output. Otherwise, heat may be generated and
cause fire.
•
Be sure to use an outlet with an earth terminal, and use the terminal correctly.
Otherwise, electrical shock or fire may occur.
•
Do not connect earth cables in the following areas :
o
Gas pipes. Doing so may cause fire or an explosion.
o
Earth terminals for telephone lines or lightening rods. Doing so may
cause a large flow of voltage if lightening occurs.
o
Water pipes or faucets. If there is a plastic part in the pipe, the earth will
not work correctly.
Caution :
•
Follow the instructions below when handling the power plug. Otherwise, fire may
occur.
o
Wipe away dust and any other residue before inserting the plug.
o
Ensure that the plug is firmly inserted as far as it will go.
•
Ensure that the plug has been disconnected from the power socket when it is not used
for a long time.
•
Earth wires must be connected to wires or terminals that fulfill the conditions :
o
Earth terminals of power socket
o
Earth wires with copper morsel that is at least 650 mm under ground
Notes :
•
If you cannot use earth terminals or find any of them, contact the shop where you
bought your printer.
•
Do not unplug the power cable when the printer is on. If the power cable has been
unplugged, leave the printer for at least 1 minute before plugging the cable in again.
1. Power cable