MUTOH Rockhopper II Series, Руководство пользователя

Страница: 138 / 190

Rockhopper II series printers – User’s Guide
138
AP-75095, Rev. 2.0, 24/10/03
5.6. OPERATIONS AFTER PRINTING
The operations performed after printing, are described here.
5.6.1. Cutting media
The media cutting procedure is described below.
Roll media is automatically cut after printing when "Auto" is set on the cut media menu and roll media has been
set.
When the operation panel is in the normal status, and the product is in the following conditions, the media can
be cut on the desired position:
•
When roll media has been set:
•
If "OFF" is set on the cut media menu
•
If "Take Up Roll" has been set in the media detection setup menu
•
When sheet media has been set
Follow the steps below to cut the media.
Step 1 : Make sure that the MEDIA SET lamp on the operation panel is off.
Plot OK
Heaters Cleaning
F3
→
Cut&Feed LeverUp
User1
xxxm
Step 2 : Press the [F3] key on the operation panel.
¾ Shift to the cut and feed menu.
* Cut&Feed *
Cut
F3
→
Forward Backward
←
F4
Step 3 : Feed media to the desired position according to the procedure in "Feeding media" .
* Cut&Feed *
F1
→
Cut
Forward
Backward ←
F4
Step 4 : Press the [F1] key on the operation panel.
¾ The media is cut at its position when the [F1] key has been pressed.