MUTOH Rockhopper II Series, Руководство пользователя

Страница: 145 / 190

Rockhopper II series printers – User’s Guide
145
AP-75095, Rev. 2.0, 24/10/03
7 Check the media for curling or liftoff. Use the recommended
media.
When using media other
than recommended media,
set the following items in
the media setting menu.
• Media
• HeadHeight
• Stiff Refer to ‘Media type’
Refer to ‘Menu setup on the
operation panel’
(12) Media is damaged during media Initial.
Notes :
Remove the jammed or damaged media.
No. Possible cause Solutions References
1 You did not use recommended
media. Use recommended media. Refer to ‘Media type’
2 The loading position of the media is
not correct. Load the media correctly. Refer to ‘Loading media’
3 You did not load the media straight
into the printer. Load the media straight
into the printer. Refer to ‘Loading media’
4 Foreign material, such a piece of
media, is attached to the pressure
rollers. Clean the pressure rollers. Refer to ‘Cleaning inside the printer’
5 You used the printer in a location
with air conditioner or other location
not appropriate for the specified
environment. Use the printer in the
specified environment. Refer to ‘Product Specifications’
6 You loaded sheet media into the
printer. Set the CutSize setting to
Length or Width. Refer to ‘Menu setup on the
operation panel’
7 You used media folded, creased,
damaged, tore, curled. Replace the media. Refer to ‘Cautions on handling
media’
(13) Tracing media or other thin media cannot be detected.
No. Possible cause Solutions References
1 You did not use recommended
media. Use recommended media. Refer to ‘Media type’
2 You used the printer in direct
sunlight or other locations not
appropriate for the specified
environment. Use the printer in the
specified environment. Refer to ‘Product Specifications’