MUTOH Rockhopper II Series, Руководство пользователя

Страница: 144 / 190

Rockhopper II series printers – User’s Guide
144
AP-75095, Rev. 2.0, 24/10/03
(9) You cannot perform initial ink charging.
No. Possible cause Solutions References
1 The front cover is open or the hold
lever is up. Close the front cover and
lower the hold lever. Refer to ‘Media handling’
2 Some of the 8 ink cartridges are not
loaded properly. Load all of the 8 cartridges
properly. Refer to ‘Installing ink cartridges’
(10) Ink is not used though you performed initial ink charge.
No. Possible cause Solutions References
1 The ink cartridge is cold or frozen. Leave the ink cartridge in
normal temperature for
three hours at least, and
perform cleaning a few
times. Refer to ‘Head cleaning’
2 You turned off the printer during the
initial ink charging. Turn on the printer to
continue the initial ink
charging. Refer to ‘Installing ink cartridges’
3 The printer rarely prints correctly
only after initial ink charging. Perform cleaning a few
times and check again. Refer to ‘Head cleaning’
(11) The media is off or damaged when loading it.
Notes :
Remove the jammed or damaged media, referring to "When media jams occur".
No. Possible cause Solutions References
1 You did not use recommended
media. Use recommended media. Refer to ‘Media type’
2 The loading position of the media is
not correct. Load the media correctly. Refer to ‘Loading media’
3 Foreign material, such a piece of
media, is attached to the pressure
rollers. Clean the pressure rollers. Refer to ‘Cleaning the inside of the
printer’
4 You used the printer in direct
sunlight or other locations not
appropriate for the specified
environment. Use the printer in the
specified environment. Refer to ‘Product Specifications’
5 You loaded sheet media into the
printer. Set the CutSize setting to
Length or Width. Refer to ‘Menu setup on the
operation panel’
6 You used folded, creased, or curled
media. Replace with new media. Refer to ‘Cautions on handling
media’