MULTIQUIP QP3Ti, Руководство по эксплуатации и запасным частям

Страница: 23 / 54

QP3Ti TRASH PUMP • OPERATION AND PARTS MANUAL —REV. #1 (05/07/18) — PAGE 23
4. Turn the AUTO/MANUAL switch on control panel to the
AUTO/STANDBY position (Figure 10).
5. Turn the DRAIN/FILL switch to the
DRAIN position
(Figure 13).
6. Turn the starter switch to the START position
(Figure 11).
7. The engine starts and pump starts draining the water
Green pilot lamp starts flashing in 1 second intervals
AUTO/FILL OPERATION
Pump starts filling with water automatically at the set low
level, utilizing float switches, then turns off at the set high
level. When the water reaches the set low level again, pump
starts filling again.
1. Prepare and connect suction hose and discharge hose
to the suction port/discharge port of pump (Figure 3).
Make sure suction hose is placed deep into the water
source and discharge hose is not kinked and lays flat.
2. Connect the terminal plugs of float switches to the float
control ports on the control panel.
3. Set the top (drain) and bottom (stop) water levels you
expect to control with the float switches (Figure 15).
NOTICE
Note that there are two ports for the float control
connection. One is for the high level ( TOP) and the
other for low level ( BOTTOM).
4. Turn the AUTO/MANUAL switch on control panel to the
AUTO/STANDBY position (Figure 10).
5. Turn the DRAIN/FILL switch to the
FILL position
(Figure 13).
6. Turn the starter switch to the START position
(Figure 11).
7. The engine starts and pump starts filling water. Green
pilot lamp starts flashing in 1 second intervals.
STOPPING THE ENGINE
8. Turn the starter switch to the OFF position (Figure 16).
Figure 16. Starter Switch (OFF)
PILOT LAMPS INDICATOR
I ) No Green or Red lights
PILOT LAMPS ALERTS
Engine running.
Auto/Standby.
III ) Green light stays on
IV ) Green light Flashing in 1 second internals
II ) Green and Red lights on Battery power supply is on.
No Battery power.
STARTER SWITCH
(OFF POSITION)
OPERATION