QP3Ti TRASH PUMP • OPERATION AND PARTS MANUAL —REV. #1 (05/07/18) — PAGE 21
OPERATION
1. Place the engine fuel valve lever (See Figure 9) to the
ON position.
Figure 9. Engine Fuel Valve Lever (ON)
2. Select the mode of operation that you require by setting
the Auto/Manual switch to either
AUTO/STANDBY or
MANUAL mode (Figure 10).
Figure 10. Operation Mode Selection
CAUTION
DO NOT attempt to start the engine unless the pump
has previously been primed with water. Severe pump
damage will occur if pump has not been primed.
AUTO/MANUAL
SWITCH
MANUAL MODE
If manual mode is selected, the pump flow can be controlled.
1. Make sure that the engine fuel valve lever is in the
ON
position (Figure 9).
2. Turn the starter switch to the
START position
(Figure 11).
Figure 11. Starter Switch (START)
3. After the engine has started, turn the flow control switch
to the desired flow volume (Figure 12).
Figure 12. Flow Control Switch
PILOT LAMPS INDICATOR
I ) No Green or Red lights
PILOT LAMPS ALERTS
Engine running.
Auto/Standby.
III ) Green light stays on
IV ) Green light Flashing in 1 second internals
II ) Green and Red lights on
Battery power supply is on.
No Battery power.
STARTER SWITCH
(START POSITION)
NOTICE
Recoil Starter is not available. Engine can only be
started with the Starter Switch on the control panel.
FLOW CONTROL
SWITCH
Содержание QP3Ti
Страница 2: ...PAGE 2 QP3TiTRASH PUMP OPERATION AND PARTS MANUAL REV 1 05 07 18 PROPOSITION 65 WARNING ...
Страница 3: ...QP3TiTRASH PUMP OPERATION AND PARTS MANUAL REV 1 05 07 18 PAGE 3 NOTES ...
Страница 33: ...QP3TiTRASH PUMP OPERATION AND PARTS MANUAL REV 1 05 07 18 PAGE 33 NOTES ...
Страница 53: ...QP3TiTRASH PUMP OPERATION AND PARTS MANUAL REV 1 05 07 18 PAGE 53 NOTES ...
