Muller 6609, Руководство по эксплуатации, Страница: 47 / 55

Mod. 6609d-6612d: Automatic Forms Cutter 13.12.2006
-47-
Service
routine
no.
Function Display when a
service routine is
started Comments
102 Standard see service
routine 9 table O For standard uses - sheet does not hang so far out of the forms cutter (lies
over both rollers in the cross cutter)
103 Paper hangs further out
of the forms cutter Sheet hangs further out of the forms cutter (is only held by the last roller).
In order to avoid paper jams at the entry to the conveyor stacker 6624,
6625 or drop stacker 6650, 6651 when operating at high speed, a greater
distance between sheets is required.
This adjustment will be transferred only when the Forms Cutter is switched
on again.
104
105 Standard
2-up special see service
routine 9 table O OMR Standard
2-up-16+16 special
106
107 Standard
48+48 marks 8+8 / 16+16 Service 134/135 apply
48+48 lines (OCB)
108
109
Paper lead-edge +
presence sensor active
Paper lead-edge +
presence sensor shut
off see service
routine 9 table O Standard: checks for lead-edge and end-of-paper
The sensor is switched off during continuous run. A fter the paper has been
positioned to the blade or read-head(Display shows ’READY’) the sensor
will be inoperative.
Notice: The cutter will NOT stop at the end of paper / end-of-web!
Use this feature for: paper backside with solid black printing or holes in
the paper web.
114
115 Doublecut
Increase see service
routine 9 / P Doublecut - Offset adjustable - 1/24"
+1/ 24"
130
131
Standard 6-7 not
crossed
head 6-7 swapped over
see service
routine 9 table O
The right hand OMR head is connected to LED-block input 7, the left head to
input 6. Head 7 is read first.
The two head 6-7 are swapped over, so 6 becomes 7 and 7 becomes 6 in the
Software.
132
133 Standard 1head
2 heads see service
routine 9 table O 1-head OMR heads 6-7
2-head OMR, (see service 134/135) may be swapped serv. 130/131
134
135 Standard 8+8
16+16 marks see service
routine 9 table O with 2-head OMR: 8+8 marks (Sequencer Digi "0")
with 2-head OMR: 16+16 marks (Sequencer Digi "1")
201
to
215 Interface
Transmit equipment
address 201-215
display range interface diagnostic: continuous
emission of adress # = service # - 200
255 Show connected
interface participants 001-015
display range Equipment addresses: 001 - master terminal, 002 - main board, 003 -
terminal, 004 - remote control, 005 - remote contro l, 008 - drop stacker, 010 -
loop control, 013 - group separation, 014 - drop stacker conveyor, 015 -online
equipment.