muli ST+PX, Руководство пользователя

Страница: 34 / 75

66 67
Charging the battery
Before you take the first ride with your e-muli st, you must charge the battery.
The battery is ready for use as soon as the LED on it lights up.
You can charge the battery on the bicycle or remove the battery from the
holder on the bicycle for charging. In either case, be sure to charge in a dry en-
vironment, preferably in a dry room. When charging the battery separately from
the bike, make sure that you place the battery on a non-flammable surface
during the charging process.
Only charge the battery with the original charger supplied.
To charge the battery, insert
1. Insert the mains plug of the char-
ger into the socket.
2. Open the cap of the charger.
Open the cap on the battery and
then insert the battery connector
of the power supply unit into the
charging socket on the battery.
Note that the charging time depends on the charger and the charge state of the
battery when charging.
For information on error indications and troubleshooting, please refer to the en-
closed system manual E6100 from Shimano from p.63ff.
Before performing any work on your e-muli such as mainte-
nance, repair, assembly or transporting it, switch off the drive
system and remove the battery. There is a risk of injury if the
drive system is activated unintentionally.
Be sure to charge the battery before use.
Be sure to read the warnings at the end of this chapter „Bat-
tery and control unit“.
In addition to this information, please be sure to read the ins-
tructions for use of the E6100 series and the E7000 series of
the component manufacturer Shimano! The instructions can
be found enclosed in printed form or on the net at:
https://si.shimano.com/pdfs/um/UM-78N0A-001-01-GER.pdf
https://si.shimano.com/pdfs/um/UM-79E0A-002-01-GER.pdf
Battery and control unit
Shimano Steps battery 500 Wh