EN - 8
◆
Unit Mi/KM Conversion
Set Unit represents unit settings.
To convert unit, press or , to increase or decrease until the
desired setting is displayed.
To store a changed setting, press the . button to access trip
distance clearance settings and the display will show OK then
returns to general selection settings interface. The default value is
Metric.
◆
Wheel Diameter Settings
Set WD represents wheel diameter settings. Electable values are 16,
18, 20, 22, 24, 26, 700C and 28. The default value is 26 inch.
To change basic settings, press or to increase or decrease until
the desired value is displayed.
To store a changed setting, press the button and the display will
show OK then returns to general selection settings interface.
◆
Speed-limit Settings
„
Set LS represents limit speed settings. When the running speed is faster than limit speed, the
eBike system will switch off automatically. Limit speed range is 12 km/h to 40 km/h (7.5
–
24.8
mph). The default value
is 20 mph.
In the user settings, this function is disabled and the settings are
password protected. Adjustments may only be made by an authorized
service center.
By default, the speed limit is set to 20 mph so that it is in accordance with the applicable legislation for
the operation of e-bikes on roads. If the maximum speed limit is set to a value higher than 20 mph, the
e-bike no longer complies with the relevant laws and may not be used for road use!
◆
Battery Power bar Settings
VOL represents voltage settings. Each bar represents a voltage value. 5 bars voltage values must
be entered one by one. For example, VOL 1 is the first bar voltage
value, the default value is 31.5V.
To set battery power bar, press or to increase or decrease the
number. To store a changed setting and access the second bar, press
the
button.
By analogy, after 5 bars voltage values is entered, hold for 2 s to
confirm and return to the previous menu.
◆
Personalized Parameter Settings
Personalized Parameter Settings can match various requirements in
use. T
Hold the and button for 2 s to enter general settings, then use
the same manner to enter personalized parameter settings selection
interface. Press the or button to choose the personalized
parameter settings items, then press the button to enter the
corresponding settings interface.
◆
Power Assistant Level option
In assistance level settings, there are 8 modes to select: 0-3, 1-3, 0-5,
1-5, 0-7, 1-7, 1-9. The default value is 0-5.
To select the mode of assistance level, press / , to increase or
decrease until the desired setting is displayed.
To store the changed setting and access the PAS ratio settings page,
press the
button.
