EN - 26
◆
“Set Clock”
Press the or (<0.5s
) Button to access the “Set Clock” menu. Then briefly press the
(<0.5s)
button to confirm selection. Now press the or (<0.5s) button and input the correct number
(time) and press the (<0.5s) button to move to the next number. After entering the correct time,
press the (<0.5s) button to confirm and save.
◆
“Information”
Once the system is turned on, quickly Press the (<0.5s) button twice to access the "SET-TINGS"
menu. Press or (<0.5s) button to select "Information", and then press the (<0.5s) button to
confirm your selection.
Or select the point "EXIT" by confirming with the (<0.5s) button to return to the main menu.
◆
Wheel Size and Speed Limit
The "Wheel Size” and "Speed Limit” cannot be changed, this information is here to be viewed only.
By default, the speed limit is set to 20 mph so that it is in accordance with the applicable legislation for
the operation of e-bikes on roads. If the maximum speed limit is set to a value higher than 20 mph, the
e-bike no longer complies with the relevant laws and may not be used for road use!
◆
Battery Information
Press the or (<0.5s) button to access the Battery Info menu, and then press the (<0.5s)
button to select confirm. Now press the or (<0.5s
) button and select "Back” or “Next Page".
Then press the (<0.5s) button to confirm, now you can read the battery information.
Content
Explanation
TEMP
Current temperature in degrees
(°C)
TotalVolt
Voltage (V)
Current
Discharge (A)
Res Cap
Remaining Capacity (Ah)
Full Cap
Total Capacity (Ah)
RelChargeState
Default Loader Status (%)
AbsChargeState
Instant charge (%)
Cycle Times
Charging cycles (number)
Max Uncharge Time
Maximum time in which no charge was made (Hr)
Last Uncharge Time
Last time in which no charge was made (Hr)
Total Cell
Number (individual)
Cell Voltage 1
Cell Voltage 1 (mV)
Cell Voltage 2
Cell Voltage 2 (mV)
Cell Voltage n
Cell Voltage n (mV)
HW
Hardware Version
SW
Software Version
NOTE: If no data is detected, "--" is displayed.
◆
Controller Information
Press the or (<0.5s) button and select "CTRL Info", and then press the (<0.5s) button to
confirm. Now you can read the controller information. To Exit press the (<0.5s) button, once
“EXIT” is highlighted to return to the information settings.
