EN - 12
◆
Switching Push-assist Mode On/Off
To activate the push-assist function, keep holding button.
After 2 seconds, E-bike is activated to go at a uniform speed of
6 Km/h (3.7 mph) while the screen displays
.
The push-assist function is switched off as soon as you release
the button. The E-bike system stops the power output
immediately.
Push-assist function may only be used when pushing the E-bike. Be aware of danger of injury when
bike wheels do not have ground contact while using the push-assist function.
◆
Switching the Lighting On/Off
To switch on E-bike headlight, hold the button for 2s. The
backlight brightness is automatically reduced. Likewise, press
the button for 2s, the bike light can be switched off.
If the front or rear light is not connected, the button can only be used to switch the display backlight
on / off.
◆
Assist Level Options
Press or . button to switch the E-bike system assist level,
change the motor output power, The default assist level
ranges from level “0”to level “5”, The output power is zero on
Level “0”. Level “1” is the minimum power. Level “5” is the
maximum power. When you reach “5”, press the
button
again, the interface still shows “5”, and blinks at“5”to indicate
the power highest. After the power downshift reaches “0”,
press the
button again, the interface still shows “0”and
blinks at “0” to indicate the power minimum. The default value
is level “1”.
◆
Battery Power Indicator
The five battery bars represent the capacity of the battery. The five battery bars bright when the
battery is in full voltage. When the battery is in low voltage, battery frame will flash at the frequency
of 1HZ to give a notice that the battery needs to be recharged immediately.
◆
Motor Power Indicator
The power of the motor is shown via digital display.
Note: The displayed value of the motor power corresponds to its
current load and in some cases the peak motor power is displayed.
