MRM LFP, Быстрый старт

Страница: 67 / 92

LFP Quick Start Guide
63
Make a note of the head’s IP address that is displayed in the pop-up;
for example 192.168.1.236.
9. To change the IP address stored in the head you can use either the
LFP or Flair. If you want to use Flair to change the head’s IP address,
or to inspect or change the SN or GW addresses, follow the
sub-steps below:
9.1 Enter the head’s existing IP address (as shown in the
Information pop-up) into the Network Setup window and click
on
Save .
9.2 Click on Load to reset and load the head.
Once Flair is connected to the head, any LAN address changes
that you make and
Save in the Network Setup window will also
affect the LAN addresses stored in the head.
9.3 To change the IP address of the head, enter the new IP address
into the Network Setup window now and click on Save .
The Status temporarily changes to Not connected as Flair
changes the IP address in the head, then to Connected as Flair
reconnects with the head at its new IP address.
9.4 To inspect or change the SN or GW address of the head, click
on Find again. A pop-up shows the head’s three current LAN
addresses, and the Subnet Mask (SN) and Default Gateway
(GW) fields in the Network Setup window become editable.
Enter the new SN and GW addresses that you want to use and
click on
Save .
10. Close the Network Setup window by clicking on Exit .
11. You are now done with the PC:
11.1 Close Flair by choosing the File > Quit menu option.
11.2 Disconnect the Ethernet cable from the PC, and re-attach it to
the LFP, so the head and LFP are now connected.
11.3 Tell the LFP which IP address to look for by following the
procedures in Managing LAN addresses with the LFP on page
58.