MRM LFP, Быстрый старт

Страница: 62 / 92

LFP Quick Start Guide
58
You can use the LFP to inspect and edit all of the above stored IP
addresses using the procedure given in the next section, Managing LAN
addresses with the LFP .
If you want, you can also use Flair Motion Control Software to inspect
and edit the actual IP address of a head with an unknown history. Details
are in
Managing LAN addresses with Flair on page 61.
Managing LAN addresses with the LFP
1. Connect the LFP and head to each other with the Ethernet cable.
2. Make sure the LFP and head have power. The menu panel on the
LFP displays a prompt similar to the following:
(C) MRMC 2016
MSA-21 v6.14.
PRESS SELECT TO
LOAD QUAD ETHER II
3. Press the
SELECT
knob to load the head.
•
If the head fails to load, you can use the remaining procedure
to find the actual IP address of the head and then specify that
IP address as the one that the LFP looks for when trying to
load the head.
•
If the head loads successfully, you can use the remaining
procedure to change the actual IP address of the head.
You can also use the remaining procedure to inspect and edit the IP
address of the LFP itself, regardless of whether the head loaded or
not.
4. Use the
SELECT
knob again to choose the following menu sequence:
CHANGE MODE
>
ENGINEERING MODE