Dodge Charger 2006 and up
1. Connect the universal VSS cable to the radar’s power/signal cable.
2. Locate the police/taxi interface connector. The police/taxi interface connector is located under the instrument
panel center stack area and can be accessed by removing the plastic cover located in front of the police
equipment mounting bracket.
3. Locate the VSS wire (Brown with Dark Blue tracer) at pin 19 and the Ground wire (Black) at pin 16 of the
police/taxi interface connector.
.
4. Using a scotch-lock t-tap and male quick-slide terminal, connect the red wire of the VSS cable to the vehicle
VSS wire at pin 19 of the police/taxi interface connector.
5. Using a scotch-lock t-tap and male quick-slide terminal, connect the black wire of the VSS cable to the ground
wire at pin 16 of the police/taxi interface connector.
6. Secure all cables and proceed to accuracy test.
Harley Davidson Electra Glide and Road King 2002-2005
1. Connect the universal VSS cable to the radar’s power/signal cable.
2. Determine the appropriate area to route the cable to connect the speedometer interface to the radar, and remove
and fairings/components to facilitate routing the cable. None of the cables should be routed next to areas of
extreme heat.
3. Remove the seat and right side frame cover from the motorcycle.
4. Remove the attaching hardware for the ECM bracket (electronic control module) and pull the ECM bracket
from the frame to access the VSS (vehicle speed sensor) connector as shown in the picture below.
.
5. Unplug the VSS connector from the wiring harness as shown in the previous picture.
6. Connect the Speedometer interface VSS cable in between the motorcycle VSS connector and the motorcycle’s
wiring harness
7. Route and secure all cables and proceed to accuracy test.
37
