Moyer Diebel 601HTG, Руководство пользователя

Страница: 33 / 114

23
1. Close the door.
2. Push the dishwasher Power Switch UP to turn the power ON.
3. The power switch will illuminate and the machine will fill with water.
4. Check the pressure gauge as the machine fills and make sure the incoming water pressure
is between 20-22 PSI.
5. Wait until the wash temperature gauge indicates a minimum of 150ºF/66ºC.
PLACE AN EMPTY DISHRACK IN THE MACHINE AND RUN THE FIRST
CYCLE EMPTY TO HEAT THE WASH TANK INTERIOR.
6. Load the dish rack into the machine. Wash one dish rack at a time.
7. Close the door, then press the START BUTTON for 1 second. The green in-cycle
light will illuminate and the wash cycle will begin. The total cycle is approximately
90 seconds.
8. Opening the door during a cycle will stop the dishwasher. If the door is open more than 5
seconds the cycle will restart from the beginning, if open less than 5 seconds the cycle
will resume where it left off when the dishwasher door is closed.
9. The final rinse cycle begins at the end of the wash cycle. The machine drains and
retains a portion of the final rinse water for the next wash cycle.
10. Check the rinse temperature gauge during the final rinse. It must indicate a minimum of
180-195ºF/82-91ºC. The final rinse water is retained for the next wash cycle.
11. During the final rinse, check the pressure gauge, located at the bottom left corner of the
front panel, to ensure the gauge reads 20-22 PSI.
12. When the green cycle light goes out, open the door and remove the rack of clean wares.
Model 601HTG -
Operation
Normal Wash Mode
Heavy Duty
Delime
Push button
Wash Temperature
Digital Display
Final Rinse
Temperature
Digital Display
Prime
Push button
Cycle
Light
Start
Push button
ON/OFF-DRAIN
Power Switch
PRIME
DETERGENT
RINSE AID
START
HEAVY DUTY
DELIME
WASH RINSE
TEMPERATURE
1 8 0 1 5 0
OFF
DRAIN
ON
POWER
6O1HTG Control Panel
! VERY IMPORTANT !
Turn the power off to the dishwasher overnight and if it is unattended
for an extended period of time.