NPort 9000 Series CLI
Commands
2-74
Usage
Guidelines
IP address: IPv4 address
Tcp-port: 1 – 65535
Examples
NPort S9650I-16-2HV(config)# interface serial 1
NPort S9650I-16-2HV(config-serif)# udp dest-ip1-begin 192.168.1.100
dest-ip1-end 192.168.1.105 dest-port1 4001
NPort S9650I-16-2HV(config-serif)# udp dest-ip2-begin 192.168.1.200
dest-ip2-end 192.168.1.205
NPort S9650I-16-2HV(config-serif)# udp local-port 4001
NPort S9650I-16-2HV(config-serif)# udp dest-port3 4003
2.3.3.16 dnp3
To configure the parameters of Modbus mode for specified serial port.
Commands
dnp3 mode {outstation|master}
Syntax
Description
dnp3
To configure the parameters of dnp3 mode.
mode
Set the mode of the device which the serial port acted.
outstation
Outstation mode
master
Master mode
Defaults
The default settings fordnp3 mode is outstation
Permission
Admin group
Usage
Guidelines
N/A
Examples
NPort S9650I-16-2HV(config)# interface serial 1
NPort S9650I-16-2HV(config-serif)# dnp3 mode master
2.3.3.17 dnp3-raw-socket
To configure the parameters of Modbus mode for specified serial port.
Commands
dnp3-raw-socket local-tcp-port
tcp-port
dnp3-raw-socket [remote-ip
ip-address
] [ remote-tcp-port
tcp-port
]
Syntax
Description
dnp3-raw-socket
To configure the parameters of dnp3-raw-socket mode.
local-tcp-port
Set the local tcp port which device used for the serial.
remote-ip
Set the remote IP address
remote-tcp-port
Set the remote TCP port
Defaults
The default settings for each parameter are:
local-tcp-port: 4001
remote-ip: empty
remote-tcp-port: 20000
Permission
Admin group
Usage
Guidelines
Ip-address: IPv4 address
TCP port: 1 – 65535
Examples
NPort S9650I-16-2HV(config)# interface serial 1
NPort S9650I-16-2HV(config-serif)# dnp3-raw-socket remote-ip 1.2.3.4
remote-tcp-port 20001
NPort S9650I-16-2HV(config-serif)# dnp3-raw-socket local-tcp-port 1234
