Movado 1881 Automatic, Руководство по эксплуатации

Страница: 16 / 72

15
NOTE: If date is adjusted between 9:00 PM and
12:00 AM when automatic date changes are already
in progress, it should be set to the following day: The
date will not automatically advance at midnight if it has
been corrected via quick mode during these hours.
To set date/time following a battery change:
1. Pull unlocked screw-down crown out to position 2;
watch continues to run.
2. Turn crown clockwise until yesterday’s date appears
in window D .
3. Pull crown out to position 3; watch stops.
4. Turn crown clockwise until today’s date appears in
window D .
5. Continue to turn crown clockwise until hands
indicate correct time.
NOTE: Be sure to take AM/PM into account when
setting time.
6. Push crown back in to position 1, and screw back
down into case.
CHRONOGRAPH FUNCTIONS
Overview
Use buttons
A
and
B
to operate the chronograph.
Pressing button
A
the first time will start the
chronograph. Pressing button
A
a second time will
stop the chronograph, allowing elapsed time to be
read. Pressing button
A a third time will restart the
chronograph. Pressing button
B
will reset chronograph
hands
C
,
E
and
F
to zero. Adjusting the time does not
stop the chronograph, but it does block buttons A and
B
for as long as the crown is pulled out.
NOTE: Crown must be in position 1 and hands must
be at zero before chronograph is started. Press button
B
to reset hands to zero.
IMPORTANT: Do not push button
A
or
B
when crown
is pulled out to position 2 or 3. If button A or B is
accidentally activated while crown is not flush against
case, one or more of the chronograph hands may
become de-synchronized. Should this occur, follow
instructions at end for synchronizing chronograph
hands.
Simple chronograph functions:
To measure the duration of a single, non-stop event:
1. Press button
A
to start chronograph.
2. Press button
A
a second time to stop chronograph,
and read the 3 chronograph hands to determine
elapsed time, for example: 1 hour, 8 minutes, 47
seconds.
3. Press button
B
to reset chronograph hands to zero.
Accumulated time functions:
To measure the combined time of a series of shorter
events, for example the actual playing time of a
football game, where play is repeatedly interrupted:
1. Press button
A to start chronograph.
2. Press button
A
a second time to stop chronograph
and read elapsed time, for example: 15 minutes,
22 seconds.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph
again, and read new elapsed time, for example:
28 minutes, 35 seconds.
NOTE: Each time you stop chronograph, chronograph
hands will indicate total accumulated time.
5. Repeat steps 1 and 2 to add each additional
interval of time.
6. After you have taken your final accumulated time
reading, press button
B
to reset chronograph hands
to zero.
7
QUARTZ CHRONOGRAPH
1/1 OF A SECOND – TYPE A
Includes 43.5 mm Movado BOLD and Series 800 Sub-Sea quartz chronographs