3.2.1
Installing the Back Bracket Assembly for SLX 5000
Prerequisites:
Unless already pre-assembled, the back bracket must be assembled on the SLX 5000
unit.
Procedure:
1
Put the unit facing down to expose the back.
2
Align the back bracket for the lifting handle to be assembled in the direction of the top panel,
where the GPS and RF ports are located.
3
Line up the four holes on the back bracket with the four threaded holes on the back of the SLX
5000 main unit.
4
Insert, screw in, and tighten four M6 x 20 screws as shown in the following figure.
NOTICE:
The tightening torque must not exceed 5.2 Nm (46.02 in.-lb).
Figure 5: Installing the Back Bracket Assembly
Top
AirSpeed
Lifting
Handle Back
Bracket
Bolts
Threaded
holes
3.3
Connecting the GPS Antenna
The GPS antenna (part number AN000378A01) is installed directly on the top of the SLX 5000 unit.
Prerequisites:
Unscrew the protective metal sealed cap from the GPS antenna jack. If the external
GPS antenna is not required (for example, when used for the 1588 Clock Sync), do not unscrew the
sealed cap.
Procedure:
1
Align the GPS jack with the plug attached to the top panel of the unit.
2
Attach the GPS antenna to the TNC connector on the main unit.
MN007322A01-B
Chapter 3: SLX 5000 Installation
26
