Page 9
SYSTEM
Quick Start Guide
Setting the machine to operate in automatic sheet feed mode
1.
Set the gap between the paper gate and the vacuum roller to approximately twice
the thickness of the stock to be creased.
2.
Place the stock to be creased onto the loading table against the fixed side lay.
3.
Release the clamps on the adjustable side lay and slide up to the paper stack
allowing a gap of approximately 0.5mm (1/64 inch) between the paper and the side
lay.
4.
Position the backstop and slide it up to the paper stack, also allowing a gap (as
stated in the above step).
5.
Turn the Emergency Stop button clockwise to switch the power on. After the
system start up procedure the touch screen will be displayed as shown below.
WARNING:-
Wait at least 10 seconds, after making any selection on the Touchscreen
panel, before switching the machine OFF. Failure to do so could result in the
data storage being corrupted, and the machine not operating.
AutoCreaser Pro 50
IMPORTANT.
If you have not been trained to operate this machine, we strongly advise that you select
the red cross icon.
We recommend that you either seek training or ask a trained operator to run the machine
for you.
Select the green tick icon only if you have been trained to operate this machine.
If you have not been trained to operate this machine and you select the green tick icon,
Morgana Systems Ltd accept no responsibility for personal injury, damage to the
machine or damage to materials being processed by the machine.