Page 29
SYSTEM
Operating the Autocreaser Pro 50
AutoCreaser Pro 50
Delete job confirmation screen.
Run the job as described on page 13. The machine will complete its creasing operation if a
sheet has already been fed through the paper gate.
In the event of a paper jam occurring whilst the machine is operating, select the Tools
tab
at the bottom of the touch screen, the display will change to that shown
below. Press the system switch down and then select the right or left arrows, to inch the
paper forwards or backwards.
In order to feed heavy stock, very small or very large sheets, embossed or even irregular
shaped sheets, it may be necessary to feed the sheets manually. The machine can be
programmed and set up in exactly the same way as explained when operating the machine
automatically. However, the paper gate must be raised to its highest position for the sheets
to be fed freely. Operating the machine in manual sheet feed mode will also require the
suction length to be continuous in order to accommodate various types of stock. Therefore,
the feed should be set to
(Vacuum Drum position 2) see page 10.
The machine can now be started by activating the System switch to ‘on’.
Select the
icon on the touch screen and begin to slide the sheets individually through
the paper gate until they are driven by the drive belts.
To stop feeding the sheets, select the
icon on the touch screen and switch the
System Switch off.
Running the machine
Paper jamming
Setting the machine to operate in manual sheet feed mode
Stream Feed
Do not activate
the Compressor switch.
Tocancel deletion of
Job press here.
To confirm deletion of
Job press here.
Inch paper in direction
of arrow to clear jams
Inch paper in direction
of arrow to clear jams
