Page 11
SYSTEM
Quick Start Guide
AutoCreaser Pro 50
Crease settings Pages.
To get to the crease setting page click the lower tab
or
from
the status area.
If you have selected a predefined standard crease type from the paper settings
page the crease positions will be set for you. These positions can be fine tuned
by ± 0.1 mm increments by pressing side arrow buttons
for each crease.
Press to remove all
creases – you will be
asked to confirm
deletion.
Scroll bar - use to bring
required crease into
view.
Cross box for deletion of crease.
On deletion of crease following
creases will move up by one
place. You will be asked to
confirm deletion of the crease.
Crease position - On selection
the status area is replaced with
a calculator for inputting new
values.
Plus box for inserting
additional creases. On
selection following
creases will move down
by one place a
maximum number of 6
creases can be seen at
any one time further
creases can be
accessed by use of the
scroll bar.
Arrows may be selected
to increase or decrease
the crease position
in 0.1mm increments
Crease on/off selector
green is on & red is off.
This is also indicated in
the status area.
Number of creases – if
more than 6 creases are
added a scroll bar will
appear to enable
viewing of all creases
Additional creases
added – scroll bar
appears for more than
six creases.
