Page 3
SYSTEM
INTRODUCTION
AutoCreaser Pro 50
The Morgana AutoCreaser Pro 50 is a fully automatic suction feeding creasing
system designed for use with both conventional litho and digital printers.
The feed on the AutoCreaser Pro 50 can also be manually operated for use
with heavy stock, very small or very large sheets, embossed or even irregular
sheets.
The crease is programmed from the leading edge of the sheet using the
controls on the front panel.
The blade and anvil are mechanically controlled over their entire length
and can be adjusted to accommodate various weights of media.
The operating environment should be controlled to a temperature between
16° C and 27° C Maximum
IMPORTANT
Specification
Feeding System ................................................ Bottom suction feed
Max. Sheet Size ................................................ 700mm x 500mm (27.5” x 19.7”) [900mm x
500mm (35.4” x 19.7”) with Optional
extension table].
Min. Sheet Size (in automatic mode)................. 210mm x 140mm (8.5” x 5.5”)
Max. Paper Thickness........................................ 0.4mm (varies according to hardness,
type of fold, and substrate)
Max. No. Creases per Sheet ............................ 16
Min. Distance Between Creases ....................... 0.1mm
Max. No. Stored Programmes .......................... Unlimited
Min. Crease Distance from Leading Edge ........ 2.5mm
Min. Crease Distance from Tail Edge ................35mm
In Hand Feed Mode up to 2499.9mm to Last Crease can be Programmed.
Speed per Hour (A4 in half) ..............................8500
Speed per Hour (A5 in half) ..............................11000
Dimensions ....................................................... L: 1500mm H: 1224mm W: 682mm
L: (59”)
H: (48.2”)
W: (26.8”)
Weight ............................................................... 156Kgs (+50Kgs packing)
Power Requirement .......................................... 1 phase 230v 50Hz
1phase 220v 60Hz
Sound Power Level ................................78.5 decibels
*As part of our continued product improvement plan, specifications and information
published in this manual are subject to change without notice.
All specifications are dependant on application, type of stock, temperature, RH and print
engine used.
Specifications quoted were measured on uncoated and unprinted stock. E & OE.
AutoCreaser Pro 50
