Page 24
CREASING
Operating the Autocreaser Pro 50
S
etting the infeed roller gap set
The gap between the infeed rollers must be adjusted to suit the stock being used. The gap
set can be adjusted as follows:-
1. Place a sample sheet of the stock to be used onto the feed bed.
2. Select the Tools tab
at the bottom of the touch screen, the display will
change to that shown below.
3. Press the system switch down and then select the left arrow on the touch screen, to
rotate the rollers in short pulses until the sheet is gripped in the infeed rollers..
4. Test the grip of the sheet in the rollers by trying to remove the sheet by hand, the
sheet should be lightly gripped by the rollers. If the grip on the sheet is too light or too
heavy it can be adjusted as follows:-
(i) Turn the gap set locking knob anti-clockwise to unlock.
(ii) Move the gap set lever up to increase the gap or down to decrease the gap.
(iii) Turn the gap set locking knob clockwise to lock.
Gap Set
Locking
Knob
Gap Set
Lever
