11
4.
Install SKIM/SKREEM Interface,
continued.
D. Remove the remaining backing on
the tape and position the antenna
loop on the tape around the SKIM/
SKREEM transceiver antenna coil,
with the stripe side facing out to-
wards the key opening. Press down
on antenna coil to ensure a strong
bond.
E. Using a supplied wire tie, secure
the antenna coil as shown.
F. Re-install the SKIM/SKREEM mod-
ule to the ignition cylinder and se-
cure with the screw. Make sure to
plug the connector back into the
SKIM/SKREEM.
G. Route two pin connector from the
antenna loop and plug into the
SKIM/SkREEM Interface. Plug the
four pin connector from the remote
start harness into the SKIM/
SKREEM Interface.
H. Close the flap on the SKIM/
SKREEM Interface and secure with
a supplied tie wrap.
123
123
123
123
123
