14
4.
Tach Rate Programming (Required for system to operate).
A. Close hood.
B. Turn the ignition to the “on” position.
C. Press and hold the programming button.
After 10 seconds the horn will
chirp and the lights will flash 3 times.
D
.
Release the programming button.
E. Press and release the programming button again.
The horn will chirp and
the lights will flash 4 times indicating the system has entered Option Bank 1.
F. Press and release the programming button again.
The horn will chirp and
the lights will flash 5 times indicating the system has entered Option Bank 2.
G. Advance to Option 2 by pressing and releasing the brake pedal 2 times.
The horn will chirp and the lights will flash 2 times indicating the system is at
Option 2.
H. Start the vehicle with the key.
The horn will chirp and the lights will flash
once approximately every 3 seconds indicating a valid tach signal.
I. Once the engine has settled to a normal idle speed, press and release the
brake pedal to set the tach rate.
J.Turn the ignition off.
Note:
If the system is not chirping the horn and flashing the lights every 3 seconds
after the ignition has started, the system is not seeing a valid tach signal.
Check your tach connection (Blue/Green at coil for gas vehicles or Dk Blue/
Gray at the ECM for diesel vehicles). Repeat the Tach Rate
Programming procedure.
Tach Rate Programming must be done before the SKIM/
SKREEM learn procedure.
