6
Component Installation
1.
Install Hood Safety Switch.
A. Using (2) of the supplied 1/4”
screws, secure hood safety switch
on driver’s side rear corner of hood
per the diagram.
Note
: Wire exits
top of switch. Switch must be
bent at 45 degree angle.
B. Using the supplied tie straps,
secure the hood safety switch
wiring to existing vehicle wiring or
brackets, be careful of moving
parts.
C. Using a supplied 1/4” screw,
secure the ground lead from the
switch to the fender frame as
shown in the diagram. The remain-
ing wire will be connected later.
2.
Install Dipole Antenna
A. Mount dipole antenna to the
windshield above the rearview
mirror.
B. Run the antenna wire above the
headliner to the driver’s A-pillar.
Temporarily remove the A-pillar
rubber gasket and run the antenna
lead down through the left side
dash opening. Replace the rubber
gasket and left side dash panel.
Ensure the antenna is securely
tucked above the headliner and is
not visible along the entire length.
123
123
123
123
123
