Moog GAT Rotopack BAT, Руководство по эксплуатации

Страница: 20 / 27

Leaks
NOTICE!
Risk of material damage to the sur-
rounding structure from leaks.
The primary and secondary sealing sys-
tems of a rotary feedthrough are subject to
wear. This can lead to leaks.
– Safeguard sensitive surrounding struc-
tures, such as bearing units, coils on
electrical machines etc., from contact
with leaked liquids.
– Replace wear parts in line with the
maintenance intervals.
Water and food
NOTICE!
Risk of material damage from transfer-
ring food.
Device designs made of steel and with
nickel-plated components are not suitable
for use with food.
– Do not transfer food through them.
– If necessary, consult the manufacturer.
6.3 Preparations
Personnel:
n Specialist staff
n Electrician
1. Switch off the machine or system in which
the device should be installed and secure
against switching on again. Block possible
mechanical movements.
2. Stop the supply of all media, electrical cur-
rent and disconnect the data lines and
secure them to prevent it from being
switched back on.
3. Allow hot components to cool down as
necessary.
4.
Check the entire installation environment of
the device to ensure that it is isolated from
the voltage and depressurised. Switch off
and secure adjacent live parts.
5. Provide surrounding machine parts, e.g.
drive motors, shaft and spindle bearings,
with constructional protection from media
leaks which may be caused by the failure of
the device.
6.4 Installation
6.4.1 Assembling the device
Tolerances
Centring devices and screw-in threads must be
precisely machined.
The required tolerance for radial run-out is 30 μm
with reference to the rotary axis.
Personnel:
n Specialist staff
Protective equipment:
n Protective work clothing
n Protective gloves
n Safety shoes
Special tool:
n Fastening material, standard screws with
strength rating 8.8
n Torque wrench
n Lint-free cloth
n
Lifting gear
1. Check the contact surfaces are clean and
remove any soiling with a lint-free cloth as
necessary.
Adhere to the Ä Chapter
7.3.1 “Cleaning the device”
on page 24 cleaning instructions.
2.
Screw the device to the flange. Adhere to
the torque values for the screws being
used.
Rotopack • Operating instructions
20