MONTAGUE M-E1, Руководство пользователя

Страница: 18 / 69

18
Pull the brake lever to make sure
the brake moves freely and stops the
bicycle. If the brake lever can be pulled
to the handlebar, the brake is too loose.
When brakes are not applied, the brake
pads should be .25-.75mm away from
the disc. If the pads are too near to the
disc, the brake is not in line or it is too
tight and the brake should be adjusted.
Examine the Steering
Make sure the stem is in line with the
front wheel and correctly attached to the
fork and handlebar.
To examine the connection to the
fork, try to turn the handlebar from side
to side while you hold the front wheel
between your knees (Fig. 5).To examine
Inflate the tires to the air pressure
recommended on the sidewall of the
tire. Improper tire pressure will cause
excessive wear, causing premature
replacement. Pressurized, unregulated
pumps should not be used for this task.
The tire should be properly seated in
the rim and the fitting of the tire bead and
rim bead should be checked. If the tube
is pinched between the tire and the rim,
it can explode when inflated. Ensure that
the tire is not cracked or unevenly worn.
Check for bulges. Check that the valve is
straight in the rim. Irregular tires should
be replaced immediately.
Examine the Brakes
Your Montague e-bike is equipped with
disc brakes The hand lever causes
the brake to apply pressure to a
disc attached to the hub. Follow the
inspection instructions for disc brakes.
Never ride a bike with an improperly
adjusted handlebar or stem as this
can cause you to lose control of the
bike, leading to serious injury or death.
Also, handlebar ends that are not
plugged or covered can cut in a crash.
WARNING
Fig. 5:
Try to turn the
handlebars while
holding the front
wheel between
your knees.
Disc brakes and discs get very hot
during use and could burn skin. Also,
the disc edges can be sharp and could
cut skin. Do not touch the disc or disc
brake when it turns or when hot.
CAUTION
BEFORE EVERY RIDE
CONTINUED
A brake system that has damage or is
not adjusted properly could decrease
your control and cause you to fall.
Inspect brakes fully before each ride,
and do not ride if brakes are not
operating correctly. Make adjustments
as needed or take to your local dealer
for service.
WARNING