![background image](http://html1.mh-extra.com/html/montague/136w36/136w36_instruction-manual_1829509008.webp)
INSTALLATION
Ceramic Radiant
(Figure 3)
1. Insert ceramic end pieces at front and rear
of the burner frame. Four (4) are required
for each burner.
2. Tilt ceramic radiants sideways to clear
burner and frame assembly, then lower
radiant into position with one flange resting
on burner ledge and one flange resting on
frame edge.
3. Install the remaining ceramic radiants so
that five (5) ceramic radiants are located
on each side of the burner.
LOCATION
Adequate clearance for service and proper
operation must be provided at the front, top,
sides, and back. The combustion air openings
are provided in the front of the unit and must
not be obstructed.
LEVELING
After broiler is positioned, check that
appliance is level both side-to side and front-to
back.
BATTERY ARRANGEMENT
Setting In Place
Model No”s 36W36, 43W36, 136W36, and
V136W36.
Floor Mounted Ranges
1. Place the first unit in the exact position it
will occupy in the battery.
2. Using a carpenter’s level, level the unit
front to rear and side to side.
An
unleveled unit will adversely affect
performance
. Adjust as follows:
FLOOR INSTALLATION ON LEGS
Level by turning foot on leg.
CURB INSTALLATION
Place shim under the low side. This operation
is important since variations in floors and
curbs are common. Unless units are level,
aligning the gas supply manifold will be
difficult and the units will not fit together tightly.
3. Remove the valve panel from the broiler.
4. Move the unit into position.
5. Engage union nut on manifold with male
fitting on next unit and draw up union nut
hand tight. Be sure appliances meet
together both front and rear. If manifolds
do not align, then units are not level. In
extreme cases it may be necessary to
loosen manifold bolts and adjust.
6. Continue leveling and connecting gas
supply manifolds together until all
appliances in battery are connected.
7.
Tighten manifold gas union. Use backup
wrench to prevent manifold from rotating.
Failure to do this may result in damage
to the pilots and gas valves.
GAS CONNECTION
Before connecting the broiler(s) to the gas
supply line, be sure that all new piping has
been cleaned and purged to prevent any
foreign matter from being carried into the
controls by the gas. In some cases, filters
6
Содержание 136W36'
Страница 31: ...EXPLODED VIEW 29 C36 C45 ...
Страница 33: ...EXPLODED VIEW 31 36W36 43W36 ...