24
SECURITY CODE AND DECIMAL POINT
__________________________________________________________________
SECURITY CODE:
Setting a security code for Programming (who can change programs) and the protection of
Management Reports.
Management Reports can be printed in either the "X" or "Z" positions on the Selector Switch. When a management report
prints in the "Z" position, transaction totals are cleared. Assigning a security code prevents accidental clearing of transaction
totals, and protects programs from being changed by unauthorized personnel. If a security code is programmed, the "Z"
report cannot print unless the security code is entered. Similarly programs can only be changed by entering the security
code.
NOTE: Assign a number easily remembered. You should also keep the program receipt as a reminder. If you do forget the
code, reset this program with a new code. Then, print the report using the new code.
Assigning a Security Code:
1.
Move the Control Switch to the "PRG" position.
2.
Enter (up to four digits) representing the security code.
3.
Press
the
[CHARGE]
key to store the code.
Example: Assign a security code of "7748":
Type Press: Display Receipt
7748 [CHARGE] 77.48 77.48 CH
NOTE: IF YOU SET A SECURITY CODE, YOU WILL NOT BE ABLE TO ALTER YOUR PROGRAM OR
PRINT YOUR MANAGEMENT REPORTS UNTIL YOUR SECURITY CODE HAS BEEN ENTERED.
THE PROMPT "SEC CODE" WILL APPEAR IN THE DISPLAY TO REMIND YOU TO ENTER THE
CODE. TO DELETE A SECURITY CODE NUMBER: ENTER THE PROGRAM MODE, TYPE [0] [0] [0]
[0] AND PRESS THE [CHARGE] KEY.
Security Code in Program Mode:
1.
In the "PRG" mode, enter the 4-digit code and press the
[CHARGE]
key. If using a Program Security code you
must always enter the code, then press [Charge] before proceeding with programming.
Using a Security Code in the "Z" Mode:
1.
To print a "Z" report when a security code has been assigned, in the "Z" mode, enter the 4-digit code and press
the
[Amt Tend/TOTAL]
key.
2.
The "Z" report will print.
SETTING THE DECIMAL POINT
To set 2 decimal place (standard in the U.S.):
1.
Move the Control Switch to the "PRG" position.
2.
Enter
[1]
,
[2]
, followed by the
[RA]
key.
3.
If finished with programming, move the Control Switch out of the "PRG" position.
THE SAME PROCEDURES APPLY FOR OTHER DECIMAL SETTINGS AS FOLLOWS:
[1] + [0] + [RA] = 0.
[1] + [1] + [RA] = 0.0
[1] + [2] + [RA] = 0.00 Standard setting for U.S.
Содержание MR-180
Страница 18: ...14...
Страница 29: ...25 1 3 RA 0 000...
