Monarch NICE 5000, Руководство пользователя

Страница: 166 / 233

7 Description of Function Codes NICE5000 User Manual
- 164 -
Function
Code
Parameter Name Setting Range Default Unit Property
F6-50
Service floors 2 of time-based
floor service 3
0–65535 65535 -
☆
F6-51
Service floors 3 of time-based
floor service 3
0–65535 65535 -
☆
F6-52
Service floors 4 of time-based
floor service 3
0–65535 65535 -
☆
These parameters define the time periods of three groups of time-based services and
corresponding service floors.
• Service floors 1: floors 1–16
• Service floors 2: floors 17–32
• Service floors 3: floors 33–48
• Service floors 4: floors 49–56
In the time period of time-based service, the elevator responds to the service floors set by
the related time-based service parameters, but ignores the service floors set by F6-05, F6-
06, F6-07, and F6-09.
The setting of time-based service floors is the same as that of service floors in F6-05.
Note
During the time-based floor service period, the settings of F6-05, F6-06 and F5-35 are invalid.
If the time periods of the three time-based services are overlapped, the system implements the
service according to the priority: Service 1 > Service 2 > Service 3.
Group F7: Intelligent Commissioning Parameters
This group of parameters is specialized for elevator commissioning.
All the settings are not saved and restore to the default setting after power-off.
Follow the instructions for normal-speed commissioning:
1. Before the commissioning, ensure that the shaft is unobstructed and the related
parameters have been set properly.
2. Run the elevator to the middle floor of the shaft at the inspection speed so as to prevent
wrong running direction.
3. Perform single-floor command commissioning and then perform multi-floor command
commissioning.
4. After the commissioning is complete, check that the parameters in this group are set
properly.
Function Code Parameter Name Setting Range Default Unit Property
F7-00 Car call floor registered 0 to F6-00 0 -
☆