Monarch NICE 5000, Руководство пользователя

Страница: 149 / 233

NICE5000 User Manual 7 Description of Function Codes
- 147 -
36: Service floor switchover
If this signal is active, the time-based service 1 remains valid.
37: Fire emergency floor switchover
The NICE5000 supports two fire emergency floors. Fire emergency floor 1 is the default
one. If this signal is active, the elevator stops at fire emergency floor 2.
38: Parking floor switchover
The NICE5000 supports two parking floors. Parking floor 1 is the default one. If this signal is
active, the elevator stops at parking floor 2.
Different parking floors can be set for different time periods. For details, see group F6
parameters.
39: Down collective selective switch
The system starts the down collective selective function when the start time set in group Fd
is reached or this signal is active.
40: Peak service
Within the peak service time set in group Fd, the system starts the peak service when the
number of car calls at the peak service floor exceeds 3 or this signal is active.
41: Fire emergency start signal
In this firefighter operation state, the elevator starts running when this signal is active.
It is used when there are special requirements for fire emergency running.
42: Back door selection signal 43: Back door forbidden signal
When opposite door control is used, these two signals are used to allow or forbid door 2.
44: Light-load signal 45: Half-load signal
It is used for allocation of elevators in parallel or group mode and nuisance judgment in the
anti-nuisance function.
46: Double door control signal
In opposite door control, if the back door is not forbidden, both doors open if this signal is
active.
47: Motor input
The group control system allocate calls to elevators in energy-saving principle when standby
power supply is used.
Function Code Parameter Name Setting Range Default Unit Property
F5-29 X29 function selection 0: Invalid
4: Safety circuit signal
5: Door lock circuit signal
4 -
★
F5-30 X30 function selection 5 -
★
F5-31 X31 function selection 5 -
★
These parameters are used to set the functions of heavy-current detection input terminals
X29 to X31.