Molecular Devices SkanWasher 300, Руководство пользователя

Страница: 46 / 78

Maintenance
36 SkanWasher 300 User Guide
Section B
Aspiration Probe horizontal position.
To be performed when columns 1-12 are not aligned to the aspiration probes.
Step 1 Set aspiration probe height through the program configuration in the
software.
Step 2 Loosen the two screws on the right side of the instrument labeled 1
and 4 one-half turn counterclockwise using an Allen key (see Figure
15).
Step 3 Loosen the nuts marked L1 and L2 one turn counterclockwise using
a 7 mm wrench.
Step 4 Adjust the microplate platform by tilting until all probes are aligned
into wells.
Step 5 Fasten the two screws.
Step 6 Verify the aspiration probes are aligned to columns 1 through 12. If
necessary, re-adjust.
Aspiration Probe row angle adjustment.
To be performed when rows A-H are not aligned to the aspiration probes (see
Figure 16).
Step 1 Set aspiration probe height through the program configuration in the
software.
Step 2 Loosen the two nut-screws on the right side of the instrument labeled
L1 and L2 one-half turn counterclockwise using a 7 mm wrench
(see Figure 15).
Step 3 Keep the two nuts stable with the wrench and adjust the two screws
labeled 2 and 3 with an Allen key. One turn equals 0.5 mm elevation
on row H.
‹
Turning screws clockwise will move row H toward the aspiration
probes.
‹
Turning screws counterclockwise will move row H away from
the aspiration probes.
Step 4 Fasten the locknuts labeled L1 and L2.
Step 5 Verify the aspiration probes are aligned to rows A through H. If nec-
essary, re-adjust.