Molecular Devices SkanWasher 300, Руководство пользователя

Страница: 33 / 78

SkanWasher 300 User Guide 23
Chapter 6: Maintenance
Daily Maintenance
Run daily maintenance (Rinse program) at the end of each run and end of day.
Decontaminate the instrument, externally and internally, after using infectious
materials in the instrument. Commercially available laboratory decontami-
nants may be used. Follow the manufacturer's directions for proper use.
Step 1 Verify rinse inlet and pressure tubing are connected between the
instrument and rinse reservoir bottle (distilled water).
Step 2 Verify waste tubing is connected to vacuum port on instrument.
Step 3 Insert a clean microplate into the microplate holder.
Step 4 Press the
[Rinse]
key to enter the Rinse/Prime mode.
Step 5 Press the
[Rinse]
key a second time to start the rinse program.
The rinse program will rinse for 5 seconds using fluid from the
Rinse port, and then soak the probe tips for 5 seconds. This
cycle is repeated 3 times.
Step 6 Remove microplate by pressing the
[Stop]
key twice.
Step 7 If end of the day, proceed with Empty Wash Head Procedure.
If further washing will be performed later the same day, turn instru-
ment off and start new wash with prime.
S
CAUTION:
Consult chemical
resistance chart to verify that
decontaminant solution will not
harm materials used in the
design of the washer.
&
TIP:
When the Rinse program is
completed, the probes will be left
soaking in liquid. If there is a pause
in washing of more than 30 minutes,
run this program to prevent
sedimentation in the probes.