Troubleshooting
29
Troubleshooting
SYMPTOM
SOLUTION
Light fittings will not
dim down to low
enough brightness
With compatible fittings, it is possible to reduce minimum circuit
brightness without causing flickering or preventing fittings from
turning on. To reduce minimum circuit brightness, see Entering
the config menus, followed by the Circuit config menu
(p.10-12)
.
Light fittings flicker
Minimum circuit brightness needs to be increased by seeing
Entering the config menus, followed by the Circuit config menu.
Light fittings fail to
light when turned on
If fittings can be dimmed down until they turn off, minimum
circuit brightness needs to be increased by seeing Entering the
config menus, followed by the Circuit config menu. If light fit-
tings dim down to a level, but will not turn back on to that level
having been switched off, boost mode is required. See Entering
the config menus
(p.10)
, followed by the Advanced circuit config
menu
(p.13)
.
Button flashing red
There is a fault with the buttons respective circuit. Check circuit
for failed light fittings.
Front fascia warm
This is normal, especially when the unit is heavily loaded.
Contact inputs don’t
work as expected
Wiring is incorrect or the wrong two-digit code has been
inserted.
Light fitting won’t
turn off
In rare cases, certain light fittings might not turn off completely
when used with SceneStyle. A different light fitting will be required.
A circuit will not dim
First, check all light fittings are dimmable. If dimmable, the
circuit has been configured as switched. To configure a circuit
as dimmable, see Entering the config menus
(p.10)
, followed by
the Advanced circuit config menu
(p.13)
.
Can’t edit scenes
If the unit has been powered for more than 1 hour, you need to
re-enable scene editing. See enabling scene editing
(p.5)
.
Circuits brightness
remains unaffected
when changing scene
Circuit has been excluded from the scene. To include the circuit
in the scene, see Advanced scene editing
(p.6)
.
Unit does not
operate
Check that the mains supply to SceneStyle is on by checking the
circuit breaker or fuse in your consumer unit.
Содержание SceneStyLED4
