Mocon AMETEK Dansensor Lippke VC1400, Руководство пользователя

Страница: 49 / 104

Dansensor
®
Lippke VC1400 EN User Guide 47
P/N 390262-B
02/2022
Error messages
NOTE! The error message list below is not complete but describes the possible
errors that the daily user has an opportunity to respond to and correct.

Other error messages may occur, but these will most often require a greater
technical insight into the device or that you contact your assigned service provider
(see
"Service" on page 74 ).
NOTE! If problems or errors occur, that are not described in this section or if one or
more errors persist, you should contact your assigned service provider (see
"Service" on page 74 ).

No. Message Problem Solution
3004 Name exists: XX This name is already used. Use another name.
3005 ID already exist: XX This ID is already used. Use another ID.
3009 Binary file version not
supported The binary file is not
compatible with the
Lippke VC1400. Check that it was the
correct file. Files from
other Dansensor
equipment can not be
imported.
3010 Printing failed The printer was not
connected or not turned
on.
Non-compatible printer is
used.
Connect and turn on the
printer.

Change to recommended
printer.
3111 Initial desiccator vacuum
too high A test can not be done if
the vacuum in the
desiccator is lower or the
same as the test vacuum. De-pressurize the
desiccator and retry.
3112 Target vacuum not
achieved The vacuum was not
achieved within the time
limits, probably because a
leakage or a defective
pump. Run a System Test to
trouble shoot.

Check whether pump is
functional and able to
create a vacuum.

Is inlet pressure high
enough? (Ejector version).

Check that sealings are
clean and intact.