90
/160
S15 Camera Manual: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
2.2.9 Replacing the MicroSD Card
If the 4 GB MicroSD card supplied needs to be replaced (for example, with a 64 GB MicroSD
card), it is best to do so
before
the camera is installed.
MicroSD cards should only be
replaced when the camera is disconnected from the power supply.
1.
Remove rotary plug
: Loosen the rotary plug at the top
of the housing, for example, using a suitable coin and
remove the plug.
2.
Remove the MicroSD card
: Carefully push the MicroSD
card into the holder using a pair of tweezers until you
hear a
click
. The card is now sticking out slightly and
can be removed using the tweezers.
3.
Insert the MicroSD card
: Push the MicroSD card as
shown (electrical contacts pointing towards the front)
into the card slot using a pair of tweezers. Make sure
that you hear a
click
when the card is inserted. The
card is now locked and can be used.
If you are using
a new MicroSD card, it needs to be formatted first
(see
Section 3.5.2, «Formatting the MicroSD Card»).
4.
Attach the rotary plug
: Insert the rotary plug as shown
and screw it tight using a coin (approximately two
turns, the plug slot is pointing forwards).
2.2.10 Tools Required for Installation
Please make sure that all the camera components are included in the original packag-
ing (see
Section 1.3.1, «S15D Core (Base Module)», Section 1.3.2, «L12 Sensor Module» and
Section 1.3.8, «S15M»).
Additional Tools/Materials Required
• Any additional materials required for attaching the camera to a ceiling/wall
(four wood screws including screw anchors and washers) are included in the
original packaging.
•
Screwdriver with PZ 2 driver bit
• Potentially a
power drill and 6-mm drill bit
for screw anchor holes for attaching
the base plate
•
Drilling template
for base plate and, where appropriate,. sensor module(at the
end of this manual)
Replace the MicroSD
card only if the camera
is disconnected from
the power supply!
Push the MicroSD card
in once (Push), then pull
out using tweezers
Click!
Click!
