Mobotix M24M Allround CS-Vario, Руководство пользователя

Страница: 108 / 148

108
/146
M24M Camera Manual: OPERATING THE CAMERA
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
3.2.5 Starting The Camera With An Automatic IP Address (DHCP)
If your network has a DHCP server, you can start the MOBOTIX camera with DHCP
support. In this case, the DHCP server automatically assigns and announces an IP address.
Note that this announcement function can be deactivated (
Admin Menu > Loudspeaker
and Microphone
).
Carry out the following steps to start the camera with a DHCP address:
1. If the camera is running, disconnect the camera's power supply.
2. Reconnect the power supply of the camera.
3. Wait until both LEDs light up simultaneously for the irst time. Press the camera's
R key
within four seconds. Use a
paper clip
, for example, for this purpose but
avoid using sharp or pointed objects!
4. After about two more seconds, the camera plays a sound ("Boing, Boing").
5. After about another 15 seconds, the camera will automatically announce its network
data, that is, IP address, network mask and MAC address. You can now access
the camera using the IP address it just announced.
Notes
Starting the camera with an automatic IP address (DHCP) is only
temporary
. The
network coniguration of the camera can be set to DHCP permanently under Admin
Menu > Ethernet Interface
.
Caution
When starting the camera with DHCP support, make sure that the network has a
functioning DHCP server. If this is not the case, the camera cannot obtain a valid IP
address and will use its last IP address.
You should also make sure that the cameras always obtain the same IP addresses
by assigning the MAC addresses of the cameras to the desired IP addresses.
In case of an error,
the camera uses its
last IP address
Press the „R“ key
Push the "R" key to
announce the net-
work data again