2.9 Mounting the D22M to a Wall Using the Wall Mount
Before mounting the
MOBOTIX D22M-IT/Secure
with the Wall Mount you need to
prepare the network connection and drill the holes for the fixtures:
•
Network connection
: The network cabling is supplied through the opening
in the back of the wall mount. The cabling is perfectly protected by the mount
and cannot be seen or damaged. The wall mount can be mounted directly
on top of wall outlets (flush-mounted or above-the-wall types; maximum
dimensions of the outlet: 88 x 80 mm (3.5 x 3.2 in) width x height).
Use the factory pre-installed network cable of the D22M (
50 cm
(
20 in
)
length). This will ensure that you can turn the lens unit of the D22M freely
later on.
•
Drilling the holes
: Prepare the holes in the wall. Make sure that you have the
supplied dowels ready for this purpose. Use the supplied drilling template for
the D22M Wall Mount (fold-out at the end of this manual) to mark the posi-
tion for drilling the dowel holes and the holes through which the cables will
be led later on.
Procedure
•
Disengage the mounting ring from the
housing
of the D22M-IT/Secure. This ring is
not required when mounting the camera to
the Wall Mount.
•
Use the delivered screws to mount the
Wall Mount (without the camera) to the
wall
(directly on top of the cabling or the wall
outlet).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
66
/108
D22M Camera Manual Part 1
Find the folded drilling
template of the D22M
Wall Mount at the end of
the manual!
Maximum torque for all
screws is 1 to 1.2
Nm
(0.74
lbf ft)
Caution
Only use the factory pre-installed network cable of the MOBOTIX
camera. It is very important that the rubber plug of the network
cable reliably protects the housing from moisture entering the
camera. All openings of the camera housing need to be closed off
properly. This will ensure that the camera remains weatherproof.
