3.6 Starting the Camera Using the Factory IP Address
In certain situations, it may become necessary to start the camera with its factory IP
address. This could be the case, for example, if the IP address has been lost or the
camera does not react to the last known IP address.
Proceed as follows to start the camera using its factory IP address:
• If the camera is powered on, disconnect the power supply of the camera by
unplugging the corresponding cable.
• Reconnect power to the camera and observe the LEDs.
• Wait until
both LEDs are lighting up simultaneously for the first time
.
• Press the
"L" key
on the camera
within four seconds
.
• After about two more seconds, the camera plays a single sound ("Boing"), if
an external speaker has been connected.
The camera is now accessible again using its factory IP address (see label on
the camera housing).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
101
/104
D22M Camera Manual Part 1
Passwords and camera
settings will not be
changed!
The D22M also allows
connecting an external
speaker and microphone.
The D22M does not have
a built-in speaker or mi-
crophone.
Make sure you store the
factory network configu-
ration to the permanent
flash memory
Users and passwords will
not
be changed!
Note
If you use the camera's
"L" key
to load the factory network configura-
tion, this configuration is not automatically saved to flash memory.
Upon restarting the camera the next time
without
using the camera's
"L" key
, the
last stored network configuration will be used. To perma-
nently store the new network configuration in the camera's flash mem-
ory, open
Admin Menu > Store ...
Caution
As opposed to resetting the camera using
Admin Menu > Reset
configuration to factory defaults
, the user information will
not
be
reset if the camera is booted using the factory IP address.
Press
"L" key
