2.5.3 Finishing the Mounting Process
Establishing a Connection to the Camera
•
Establish a connection to the camera
as described in section 3.4,
Establish-
ing a Connection to the Camera.
Adjusting the Lens, Visual Check
Make sure that you see the live image of the camera on the monitor of your com-
puter or laptop. Now adjust the lens until you see the desired image area on your
monitor.
•
Remove the camera dome.
Take the deliv-
ered plastic foil or a cotton cloth and remove
the dome by turning it in counter-clockwise
direction. Make sure that you remove the
camera's outer shell on IT/Secure models
before you attempt to do this.
•
Slightly loosen the toothed ring
inside by
turning it in counter-clockwise direction using
the supplied toothed wrench.
Also slightly
loosen the two Allen screws at both sides
of the lens unit
by turning them in counter-
clockwise direction using the supplied Allen
wrench.
Loosen the outer shell and the Allen screws
only slightly, so that you can turn the internal
part of the camera and tilt the lens unit with-
out using excessive force. The internal part
and the lens unit should not reposition them-
selves.
•
Fine-tune the image area that is displayed
on a computer monitor
by turning and tilting
the lens unit accordingly. Never use force
when adjusting the direction of the camera,
as this could damage the camera beyond
repair. The internal part of the camera with
the lens unit should turn and tilt easily, but it
should not reposition itself.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
56
/108
D22M Camera Manual Part 1
