VAP Monitoring and Configuration
LTE 700 MHz MobileAccessVE Instant Coverage Solution User Manual
66
The following table provides a description of the displayed VAP RF parameters (in SISO service
mode, only
Channel 1
parameters are displayed).
Parameter
Description
Type
Set (Read Only) according to unit type (LTE)
Channel 1/
Channel 2 Antenna
External only (default).
DL Pout Level
Level of from BS side.
Normal = output power will be at required (normal) level
Low = output power will be attenuated by 5 dB less than the required level.
This option can be used for smaller coverage areas that do not require the
full power of the VAP for coverage.
Channel 1/
Channel 2 DL Pout
Measured output power. Normal output power is approximately 14dBm.
Note: VAP RF settings (Service Mode, DL Pout Level, Antenna) are saved in the VCU associated
to the port to which the VAP is connected. If you replace a VAP, all parameters are automatically
set to the new VAP. If you do not want to keep that configuration of the replaced VAP, remove it
from the topology baseline prior to connecting the new VAP.
