Mitutoyo 542-071, Руководство пользователя / Инструкция по эксплуатации

Страница: 27 / 76

3 Setting Parameters
13
No. 99MBC109B
No. Setting item
Description/Allowable values
(the values in bold indicate the default value)
Counter model
P Z S D
05
Origin detection
function Selects whether the origin is restored when a Linear
Gage with an origin point mark is connected.
○ ● ○
0: Disabled 1: Enabled
09 Unit system selec-
tion The unit for displayed values can be set to "mm" or "E
units". E=1/25.4 mm. After the unit is set, the default value
will not be restored even if the parameters are re-initialized.
● ● ● ●
0: mm
1: E 5/100,000 reading
2: E 1/10,000 reading
3: mm (E 1/10,000 reading when connecting. EH-D only)
10 Linear Gage output
signal pitch*
1
Sets the signal pitch when connected to Linear Gages
that output sine-waves. It can be set per axis.
●
0: 20 µm
2: 0.25 µm
1: 4 µm
11 Counter direction Sets whether the numeral will increase or decrease
when the spindle of the Linear Gage is pushed in. It
can be set per axis.
● ● ● ●
0: + direction 1: - direction
12 Linear Gage reso-
lution
*1
Sets the resolution of the Linear Gage that is to be
connected to. It can be set per axis.
● ● ● ●
EH-P/Z
0: 10 µm
1: 5 µm
2: 1 µm
3: 0.5 µm
4: 0.1 µm
5: 0.1 µm
( exclusive for
542-711-1 and
542-712-1)
EH-S* 2
0: 10 µm
1: 5 µm
2: 1 µm
3: 0.5 µm
4: 0.1 µm
5: 0.05 µm
6: 0.01 µm
7: 0.005 µm
8: 0.001 µm
EH-D* 3
0: INC
1: ABS
*
1
The Preset value and tolerance value that had been set will be cleared if the setting is changed.
* 2 The setting range depends on the value set for parameter number 10.
Parameter number 10 = 0: setting range 0 to 4
Parameter number 10 = 1: setting range 2 to 6
Parameter number 10 = 2: setting range 4 to 8
* 3 Select "0: INC" when the Linear Gage that is to be connected to is an INC model. "0: INC" or "1: ABS"
can be selected when the Linear Gage is an ABS model.
When "0: INC" is selected:
Match the counter value of both the Linear Gage and the Counter when starting up the Counter. Perform
Zero setting, etc., on the Linear Gage side when performing measurement with the values matched.
When "1: ABS" is selected:
The Counter memorizes the origin (0 point) that was set at Counter startup. The origin that was
memorized will be valid even if the Counter is re-started.