Mitsubishi Lancer Sportback, Руководство пользователя, Страница: 46 / 433

NOTE
l If the engine is cold, the diesel preheat indi-
cation lamp is on for a longer time.
l When the engine has not been started within
about 5 seconds after the diesel preheat indi-
cation lamp went out, return the ignition key
to the “LOCK” position. Then, turn the emer-
gency key to the “ON” position to preheat
the engine again.
l When the engine is warm, the diesel preheat
indication lamp does not come on even if the
emergency key is placed in the “ON” position.
Start the engine by turning the emergency
key right to the “START” position.
10. Turn the emergency key with the keyless op-
eration key to the “START” position without
depressing the accelerator pedal, and release
it when the engine starts.
NOTE
l Minor noises may be heard on engine start-
up. These will disappear as the engine warms
up.
Using the MIVEC engine
The MIVEC engine automatically controls
valve timing in accordance with driving con-
ditions for maximum engine performance.
NOTE
l To protect the engine, the high-speed mode
may not be selected while the engine coolant
temperature is low.
11. Remove the keyless operation key from the
emergency key.
WARNING
l Make sure to remove the keyless opera-
tion key from the emergency key after
the engine is started.
If not removed, the keyless operation key
could fall to the floor, which could dis-
turb the pedal operation. Furthermore,
the keyless operation key could prevent
the driver’s knee airbag from inflating
normally or could be propelled to cause
serious injury if the airbag inflates.
NOTE
l
If the emergency key is attached to a key hold-
er, it may become impossible to insert the key-
less operation key into the emergency key,
and it may prevent the engine from being star-
ted. When using the emergency key to start
the engine, first remove the key from the key
ring.
Keyless entry system
E00307700693
Press the remote control switch, and all doors and
the rear hatch will be locked or unlocked as de-
sired. It is also possible to operate the door outside
rear-view mirrors.
1- LOCK ( ) switch
2- UNLOCK ( ) switch
3- Indication lamp
To lock
Press the LOCK switch (1). All the doors and rear
hatch will be locked. The turn-signal lamps will
blink once.
NOTE
l With a vehicle that has a Dead Lock System,
pressing the LOCK switch (1) two times in
succession causes the Dead Lock System to
be set. (Refer to “Setting the system” on
page 1-29.)
Locking and unlocking
1-23
1
OG4E12E1