Mitsubishi Lancer Sportback, Руководство пользователя, Страница: 213 / 433

Type 2
NOTE
l If the cruise control is on when the ignition
switch is turned to the “LOCK” or “ACC” po-
sition, cruise control will be on automatically
the next time you start the engine. The
“CRUISE” indication lamp will also be on.
l If the battery voltage is insufficient, the mem-
ory data for the cruise control may be erased.
As a result, the “CRUISE” indication lamp
may not come on when you restart the engine.
If this happens, press the “ON OFF” switch
once again to turn on the cruise control.
2. Confirm that the Twin Clutch SST control
mode is set to “NORMAL” (on vehicles
equipped with Twin Clutch SST). Refer to
“Twin Clutch SST control mode” on page
4-35.
NOTE
l The cruising speed cannot be set when the
Twin Clutch SST control mode is set to
“SPORT” mode.
3. Accelerate or decelerate to your desired
speed, then press and release the “COAST
SET” switch (B) when the “CRUISE” indica-
tion lamp is illuminated. The vehicle will
then maintain the desired speed.
Type 1
Type 2
NOTE
l When you release the “COAST SET”
switch, the vehicle speed will be set.
To increase the set speed
E00609400541
There are 2 ways to increase the set speed.
“ACC RES” switch
Press and hold the “ACC RES” switch (C) while
driving at the set speed, and your speed will then
gradually increase.
When you reach your desired speed, release the
switch. Your new cruising speed is now set.
Type 1
Type 2
To increase your speed in small amounts, press the
“ACC RES” switch for less than about 1 second
and release it.
Each time you press the “ACC RES” switch, your
vehicle will go about 1.6 km/h (1 mph) faster.
Starting and driving
4-56
4
OG4E12E1