34
35
NetCommand® Setup, continued
Review Screen
(Figure 9)
Once you have made all your device choices you will see
the Review Screen. It is important to review the settings
to ensure that they are correct. If necessary, you can
navigate Back through the NetCommand Setup screens to
make changes. On this screen, adding or deleting check
marks will turn On or Off the adjacent Input or Device.
Note: The Review screen lists HDTV Receiver Input
and A/V Receiver Input used with each device. Verify
that these are the inputs you used when you connected
the devices. If you have not connected your devices, write
down these inputs as a guide. If you need to change these
inputs, or if you would like to change the name of a device,
select Edit NetCommand to make necessary changes.
Note: If you select Next>, all selections made are finalized.
While viewing the Review Screen, adding or removing
checks from the checkboxes on the left will turn devices
(or inputs) On or Off. Select On to have the device display
in the Device Selection Menu.
Finish Screen
(Figure 10)
When the Finish Screen is displayed, all selections are
finalized. Select Finish to complete setup.
Note: If you wish to change any of the pre-configured
inputs or names for the devices, or add devices not in the
pre-configured setup, select the Edit button to display the
Edit NetCommand menu.
Available channels for Ant-A, Ant-B and Ant-DTV
should now be memorized. Press Menu to display
the Main Menu, then select Antenna. Instructions to
memorize channels are found on the Antenna Menu, page
.
Figure 9. Review screen
Figure 10. Finish screen
